RV Pre-Departure Checklist

Interior

• All seven drawer latches are depressed.
• Refrigerator latches (2) are engaged.
• Refrigerator is set for battery (optional).
• Green switch for fridge is on (optional).
• Loose items are stowed and secured.
• Roof vents (2) are retracted and locked.
• Windows (3) are fully shut and latched.
• Bathroom door is shut.
• Alde is turned off.

Exterior Walkaround

• All four stabilizer jacks are retracted.
• Propane is turned off.
• Step up is stowed.
• Door is locked.

Connections

• Shore power disconnected and stowed.
• Grey/Black water discharge cover in place.
• City water disconnected and stowed.
• Water manifold is set for “Dry Camping.”

Covers

• Red Bin #1 is latched and locked.
• Red Bin #2 is latched and locked.
• Center Bin is latched.
• Heat pump cover is removed.
• Side storage cover is latched.
• Water manifold cover is latched.

Hooking up

• Hitch is latched with clip in place.
• 7-pin connector is locked in place.
• Chains are crossed and locked in place.
• Breakaway cable is connected.
• Trailer tire boot lock is removed.
• Wheel chocks (2) are removed.
• Tongue jack is fully retracted.
• Antisway bar is installed and pinned.
• Towing mirrors are mounted and adjusted.
• Lights are tested.
• Remote Tire Pressure Sensor is on.

• FINAL WALK AROUND

T@B 400 Arrival Procedure

• 1.     Remove the antisway bar before backing.
• 2.     Check level left to right. Correct as needed with leveler system.
• 3.     Set the tow vehicle parking brake.
• 4.     Chock both trailer wheels, ahead and behind wheels.
• 5.     Partially lower tongue jack. Mount the front wheel to the jack. Install the wheel pin.
• 6.     Lower the tongue jack until the wheel engages with the ground.
• 7.     Chock the tongue jack wheel with the chain line.
• 8.     Remove hitch latch clip pin. Pull the coupler back to release the ball hitch when lifting.
• 9.     Extend the tongue jack and lift the tongue off the ball.
• 10.   Remove the safety chains, breakaway lanyard, and 7-pin connector.
• 11.   Verify clear, then move the tow vehicle forward to clear the tongue.
• 12.   Raise/lower the tongue jack to level the trailer front to back.
• 13.   Set the jack pads and extend all four stabilizer jacks.
• 14.   Connect to shore power using EMS surge protector.
• 16.   Connect to city water. Spiggot => pressure reducer => Y-connector => filter => hose.
• 15.   Open the propane valve.
• 16.   Install hitch lock and trailer tire boot lock.